|
|
Ford Trucks
This category is proof that it's not just Ford cars that exemplify the meaning FordMuscle. Whether it's a rock crawling Bronco, supercharged Lightning, or anything in between, we want to see you show it off here! |
|
|
|
 |
|
This is my daily driver. It's got an AT, PS, and AC. The new 306 runs great with the recently added Hooker Comps, X-pipe and 2.5" exhaust. The motor has C9OE 351W heads that I ported and rebuilt with Rev valves and Comp roller tip rockers. I'm running a Holley 600 VS on top with an Edelbrock Performer intake. Lately I've been rewarded with 12 mpg...way better than the 8 I was getting with the old ***sick*** 302!!! |
|
 |
1/4 Mile:??? CID:306 Rearwheel HP:Est250@5K Torque:???@5K
View My Page |
|
|
|
|
Motorhead |
1985 Ranger shortbed 2wd
|
|
|
1965 289 block and crank, H-beam rods, 9.3:1 KB pistons, Comp 282S cam (236 @ .050, .528 lift), Windsor Jr. heads, Weiand Xcelerator intake, Holley 780dp, Ram Air, MSD Pro Billet RTR dist., James Duff headers, dual 2.5" exhaust: single Dynomax race-flo dual 2.5" inlet/outlet muffler, Centerforce2 clutch, Lakewood scatter shield, T5-Z tranny, 3.73 Trac Loc 8.8" rear, lowered 2", 1997 Cobra Mustang wheels, 245-45-R17, rattle-can stripes :) |
|
 |
|
1/4 Mile:13.21 MPH:105.2 60ft:1.96 Weight:3200 CID:289 Flywheel HP:350@6500 Torque:350@4500 |
|
|
|
|
|
Mud drag truck |
|
 |
|
CID:408 Rearwheel HP:650@7200 |
|
|
|
|
|
408w with top proline 215 heads, scat crank, scat 6.250 Hbeam rods, custon cam research cam, 12to1 comp. vic Jr intake and mighty deman 850. C-4 auto with TCI manual valve body. 4.10 gears with a spool in the back going to a set of 35x14.50x15 super swamper boggers. |
|
 |
|
1/4 Mile:3.35 CID:408 |
|
|
|
|
ronsford56 |
1956 ford f100
|
|
|
ford 9 inch, 351c auto fmx |
|
 |
|
CID:351 Rearwheel HP:315@0000 |
|
|
|
|
amsounds |
2006 Roush Stage 1 F-150
|
|
|
06 Roush Stage 1 F150 mildly modified by Troyer Performance, 5.4 has been Stroked to 2 cubic Inches and transmission valve body modified. Just got the Thumper Cams for the motor and BBK 90mm Throttle body. Can't wait to get them installed. Also planning on the twin turbo set up by Helion in the near future! |
|
 |
|
Weight:5620 CID:333 Rearwheel HP:400@5100 Torque:390@3200 |
|
|
|
|
|
351W bored .040 over, Comp Cams Extreme Energy XE268H, GT40P Performance Heads, Edelbrock Performer Manifold & 750 CFM Carb, Ford Motor Sports Headers for the GT40P Heads, C6 Trans, 9" 3:50:1 Posi - Wood Bed |
|
 |
|
1/4 Mile:14.78 MPH:91.56 60ft:2.14 Weight:4000 CID:351 Flywheel HP:380@5500 Torque:400@4400 |
|
|
|
|
RWSilknitter |
2001 Ranger Edge
|
|
|
In the Process of Build |
|
 |
|
CID:347 |
|
|
|
|
